ESC regulator HGLRC 60A 6S V1 ESC

Buy power and reliability - ESC controller HGLRC 60A 6S V1 for quadcopter!

ESC controller HGLRC 60A 6S V1 is a high-performance controller for motors. This model is designed for demanding racing and freestyle projects. It provides powerful and stable current for dynamic flights. You'll get smooth response and precise traction control. This regulator will form the basis of your drone's powertrain.

Five main advantages 

• High continuous current 60A for powerful motors.

• Full support for batteries up to 6S (25.2V).

• Reliable BLHeli_S firmware with Damped Light function.

• Compact aluminum housing for efficient cooling.

• High-quality components for stable operation under load.

Purpose and principle of operation of the regulator

ESC HGLRC 60A 6S V1 controls the quadcopter's brushless motor. It receives digital signals from the flight controller. The microprocessor interprets thrust change commands. The circuit generates three-phase alternating current for the motor. This allows you to change the rotation speed accurately and quickly.

The key task of the regulator is to supply the required power to the motor. It works as a high speed electronic switch. The efficiency and responsiveness of the entire power plant depends on its quality. The Damped Light function provides effective braking of the propeller. This improves the overall controllability of the copter in the air.

Specifications and Features

The technical parameters of the ESC demonstrate its capabilities. Continuous operating current is 60 Amps. Peak current (burst) reaches 80A within 10 seconds. The regulator supports batteries from 2S to 6S (25.2V). This is sufficient for most high-performance racing configurations. Compact aluminum body dissipates heat.

The dimensions of the board and case are optimized for installation. Low-impedance MOSFET transistors are used for minimal losses. Input capacitors filter noise from the battery. The board has a protective coating against moisture and short circuits. Convenient solder pads are used for connection.

The regulator runs on proven BLHeli_S firmware. It provides high response speed and stability. Modern protocols are supported: DShot1200, Multishot, Oneshot. Configuration is performed through convenient programs on a PC. The throttle curve, rotation direction and braking parameters can be adjusted.

Specifications

• Input voltage: 7.4V-25.2V (2V-6V)
• Operating current: Rated current per channel 60 A, maximum current in four channels 190 A
• ESC firmware: Q-H-40
• Dimensions: 37mm * 43mm
• Mounting hole: 30.5*30.5mm, M3
• Weight: 14 g.