FPV drone Happymodel Crux3 1S ELRS

Wheelbase: 115 mm
Size: 97mm x 97mm x 35mm (excluding propellers)
Weight: 40 g (without battery)
Motor Mode: EX1202.5 KV11500
Configuration: 9N12P
Stator diameter: 12mm
Stator length: 2.5mm
Shaft diameter: Φ 1.5mm
Motor size (diameter * length): Φ 14mm * 14.5mm
Weight (g): 4.4g
Number of cells (Lipo):1S
Propellers Gemfan 75 mm
Center thickness: 5mm
Support diameter: 75 mm
Center Hole Diameter: 1.5mm
Pitch: 0.9 inch
Flight Controller Microcontroller: STM32F411CEU6 (100 MHz, 512K FLASH)
Sensor: MPU-6000 (SPI connection)
Compatible with original Whoop size
Power Source: 1S Battery Input (DC 2.9-4.35V)
Built-in 5A (each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD (SPI controller)
Built-in 5.8G video transmitter
Built-in SPI ExpressLRS 2.4GHz receiver Built-in 5V 1A BEC controller Firmware target: CRAZYBEEF4SX1280
Built-in 4 in 1 EPC MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak, 6A (3 seconds)
Programmable BLHeliSuite support
Factory Firmware: O_H_5 _ REV16 _ 7.HEX
Default protocol: DSHOT300
Built-in 2.4GHz SPI ExpressLRS receiver Packet rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
RF Frequency: 2.4GHz Antenna: SMD antenna
Telemetry output power: 52 dB (AGC OFF)
Video output: CVBS
Lens: 1.8mm
Min. Illumination: 0.001Lux@F1.2
Automatic Gain Control: YES
BLC: YES
WDR: Global WDR
DNR: 3D DNR
Dimensions: 14*14 mm (with bracket up to 19*19 mm)
Wide power input: 3.7-18V DC
Operating temperature: -20~+60
Weight: 2g (N.W.)