ESC regulator HGLRC ICE 150A SBEC

Choose power and control - the HGLRC ICE 150A SBEC ESC controller for your drone!

ESC controller HGLRC ICE 150A SBEC is the pinnacle of power and efficiency. This model is designed for professional racing and freestyle quadcopters. It provides uninterrupted power supply to the most demanding motors. You will experience maximum responsiveness and smooth traction control. This regulator will form the backbone of your powerful drone's power system.

Five main advantages 

• High continuous current of 150A for extreme loads.

• Built-in SBEC with adjustable output voltage.

• Support for modern BLHeli_32 control protocols.

• Efficient passive cooling system.

• Reliable capacitors to suppress electrical noise.

Operating principle and purpose of the regulator

ESC HGLRC ICE 150A SBEC controls the speed of the brushless motor. It receives signals from the drone's flight controller. The microprocessor decodes the commands and generates three-phase current. This current is supplied to the motor windings in strict sequence. This ensures a smooth and precise change in rotation speed.

The built-in BEC (Battery Eliminator Circuit) is a key feature. It converts high battery voltage into stable 5-12V. This voltage powers the on-board electronics: controller, receiver, camera. You don't need a separate battery for low-power devices. The system becomes lighter and easier to assemble.

Technical characteristics and functionality

The technical parameters of this ESC are impressive. Continuous current is 150 Amps. The peak (burst) current reaches 200A within 10 seconds. The regulator supports batteries up to 6S (25.2V). The built-in SBEC produces stable 5-12V at currents up to 8A. This is enough to power the entire on-board network.

The dimensions of the board are optimized for installation in the power part of the frame. Power MOSFET transistors with low resistance are used. This minimizes energy loss and heating. The board is coated with a protective varnish against moisture and short circuits. High-quality gold-plated terminals are used to connect the motor.

Management is carried out through modern digital protocols. DShot1200, Proshot, PWM and Multishot are supported. The BLHeli_32 firmware allows fine tuning of all parameters. You can adjust damping, timing and throttle curve. This is done through convenient configurators on your computer.

Specifications

• Constant current: 150A
• Maximum current: 160 A for 10 seconds.
• Input voltage: 2-6 cells Li-XX or 6-16 Ni-MH/Ni-Cd.
• BEC output: 5.5V/6A
• PWM: 8-16 kHz
• Maximum speed per minute: 240,000 rpm for 2-pole brushless motor
• PCB size: 50mm*30mm
• Weight: 93 g.