1 点の商品
Extend control and telemetry over kilometers without signal loss. LORA radio modules are specialized devices for long-distance communications. They operate at sub-gigahertz frequencies with low power consumption. These modules provide stable communications far beyond the line of sight. You will be able to control the drone at distances of tens of kilometers.
Very long communication range in cities and open areas.
High noise immunity and ability to penetrate obstacles.
Low power consumption for long battery life.
Ability to build networks with multiple devices.
Relatively low cost of deploying a communication channel.
LoRa (Long Range) is a method of modulating a radio signal. It is optimized for transmitting small data over long distances. Unlike Wi-Fi or regular radio, LoRa sacrifices speed. But it wins in reception sensitivity and energy efficiency.
The system consists of two devices: a transmitter and a receiver. A compact module with an antenna is installed on the drone. On the ground - a base station connected to a laptop or controller. They exchange data packets on a fixed frequency. Most often, 433 MHz, 868 MHz (in the Blastdrak) or 915 MHz.
LoRa modulation is resistant to Doppler shift and multipath propagation. This allows you to maintain contact with a fast-moving drone. Even when he goes behind a building or hides behind a hill.
One of the most popular chips isSemtech SX1276/SX1278. Most of the modules are built on them. For example,RFM95WorE22-400T22S. These modules operate in the 410-525 MHz range.
The key parameter is the transmitter power. It can reach +20 dBm (about 100 mW). This provides enormous range with modest power consumption. Reception sensitivity is up to -148 dBm. This allows you to pick up very weak signals.
For convenience, ready-made converter boards are used. For example,LoRa RA-01orEbyte E22. They have a 3.3V logic level and are connected via SPI or UART interface. This makes them easy to integrate with any flight controller. For example, with Pixhawk or an Arduino-based autopilot.
More advanced solutions -modules with built-in microcontroller. For example,Dragino LPS8orRAK4270. They already contain a processor to process the protocol. And they can work as independent telemetry stations.
The main application is advanced telemetry and telemetry (MAVLink). The flight controller (ArduPilot, PX4) sends all data via LoRa. Coordinates, altitude, battery status, sensor readings. The ground station receives them and displays them on the map in real time.
The second application is a backup control channel. If the main 2.4 GHz channel (RC) goes down, LoRa takes over. The operator can send a command to return or land. This is critical for BVLOS (beyond visual line of sight) flights.
The third is the creation of mesh networks for a swarm of drones. Several devices can relay the signal to each other. This further increases the coverage area and reliability of the system.
To operate, you need a couple of devices: on the drone and on the ground. Both must be tuned to the same frequency, SF and BW. Antennas must be selected for the operating range (for example, 433 MHz). And position them correctly for the best radiation pattern.
The connection to the flight controller is usually via UART. In the firmware (ArduPilot) you need to activate the corresponding serial port. And specify it as the source/receiver of MAVLink telemetry.
The transmitter power should be selected according to the distance. For 10-15 km in urban conditions, 50-100 mW is often enough. In open areas, the range can reach 30-40 km or more.