Engine RCinPower GTS V3 0702 27000KV

Order the ultra-light RCinPower GTS V3 0702 27000KV motor for your Tinywhoop drone!

Get maximum power in minimum weight for your micro drone. The RCinPower GTS V3 0702 27000KV motor is designed specifically for the smallest FPV drones such as Tinywhoop and Toothpick on 1S. The 7x2mm stator size and incredibly high KV 27000 provide explosive dynamics and excellent thrust for the 65mm propellers.

Unibell's innovative unibody design resists impacts from hard landings. Choose cutting-edge technology for your miniature projects. Order RCinPower GTS V3 0702 right now in our store.

• Record low weight of only 1.5 grams with cable for ultra-lightweight designs.

• High quality workmanship with two precision ball bearings for smooth running.

• Robust, one-piece Unibell construction for maximum reliability.

• Pre-installed connector for quick connection to the flight controller without soldering.

• 9N12P configuration for efficient operation and excellent torque.

Operating principle and workmanship

The RCinPower GTS V3 0702 motor belongs to the class of brushless motors for micro-drones. Its Outrunner design and 9N12P configuration (9 coils, 12 magnets) provides the perfect balance of power and efficiency for small propellers. The high KV of 27,000 allows the engine to spin up to the extreme speeds necessary for dynamic piloting in confined spaces.

A key feature of the V3 is the Unibell design, where the rotor housing is made from a single piece of material. This significantly increases durability and shock resistance during frequent falls. Two high-quality ball bearings ensure smooth running and durability even under maximum loads. The cables are soldered to a printed circuit board at the base of the motor, which minimizes the risk of damage to the windings if the wire is accidentally pulled.

Specifications and installation

Study the detailed parameters of the RCinPower GTS V3 0702 27000KV motor. The stator size is 7 mm in diameter and 2 mm in height. The shaft diameter is 1 mm. The mounting holes are made according to the 6.6 mm pattern for M1.4 screws. Cable length 3 cm with pre-installed connector for direct connection to the flight controller. The weight of the device with cable and connector is only 1.5 grams.

This motor is ideal for 65mm drones (Tinywhoop) and lightweight toothpick designs on 1S. Thanks to the pre-installed connector, replacing the motor in the field takes just seconds without the need for soldering. A set of mounting screws is supplied with each motor.

Areas of application and operation

The RCinPower engine is designed for indoor and outdoor racing and freestyle racing. It performs great on Tinywhoop class drones, providing lightning fast throttle response and stable hover. High efficiency allows you to stay in the air longer, enjoying the flight. Easy plug-in motor replacement makes it an ideal choice for new and experienced pilots who change components frequently.

Specifications

• Stator size: 0702
• KV: 27000KV
• Configuration: 9N12P
• Voltage: 1S LiPo
• Shaft size: 1mm
• Mounting holes: center diameter 6.6 mm, M1.4 thread
• Wire length: about 30mm with connector
• Bearings: double ball bearings
• Weight: approximately 1.5 g (with wires and connector).